Changing from ARK eCFW to TN-V on 3.51/52

[Smoker1]

OK, I am on 3.51, and I have ARK eCFW running under Pool Hall Pro. I see that I can be able to get TN-V back up and running under 3.51, but kind of confused with how to get it done. How would I go about doing this?
Do I go and remove completely the ARK Folder and PHP Folder and put back the Original then do as this Tut goes, or is there something different?
http://wololo.net/2015/10/04/tutorial-i ... -psp-game/

Advertising

[qwikrazor87]

You can leave the ark files alone, just grab TN-V PBOOT.PBP, then use PSP Filer in ARK to copy it here:
ms0:/PSP/GAME/NPUH10091/PBOOT.PBP
backup Pool Hall Pro game from Vita to PC with Content Manager, then restore it back to the Vita.
Transfer TN-V save to Vita.
You should now have TN-V where ARK was.

Advertising

[Smoker1]

OK, so verification:
Basically just leave everything how it is currently for ARK.
Take the TN PBOOT File, place it over to my Vita, then using Filer place it in the PHP Folder
Backup the Game, then send it back to the Vita (If anything, do this part 2x)
Take the TNV_00000 and Transfer to Vita
Should be good to go?
Just Start Game Bubble, hold R, Setup and everything is Set?
Will I need 660.PBP in the PHP Save Folder?

[qwikrazor87]

OK, so verification:
Basically just leave everything how it is currently for ARK.
Take the TN PBOOT File, place it over to my Vita, then using Filer place it in the PHP Folder
Backup the Game, then send it back to the Vita (If anything, do this part 2x)
Take the TNV_00000 and Transfer to Vita
Should be good to go?
Just Start Game Bubble, hold R, Setup and everything is Set?
Will I need 660.PBP in the PHP Save Folder?

you got it.
Edit:
660.PBP goes in TNV_00000.

[Smoker1]

Unable to Move the TN PBP File to NPUH10091.

[qwikrazor87]

Unable to Move the TN PBP File to NPUH10091. Thinking may have to Backup the Game, and replace it on my PC then put it back on my Vita that way, then continue with the Process.

try updating your ARK_01234 save from this thread, grab it from the correct firmware that you need.
viewtopic.php?f=58&t=44592

[Smoker1]

OK, yeah, I think I am using the one for 3.50. Swear I thought I was using for 3.52 and Below. So just swap out the ARK and PHP Save Folders, Boot, then try again?

[qwikrazor87]

OK, yeah, I think I am using the one for 3.50. Swear I thought I was using for 3.52 and Below. So just swap out the ARK and PHP Save Folders, Boot, then try again?

since you already have the bubble installed, just install the new ark save.

[Smoker1]

Keep getting this

20151010_220146.jpg (149.75 KiB) Viewed 2851 times

Im thinking I need to do it the way I was thinking before. Remove the ARK, and PHP Saves, and also now remove the TN. Then just need to Exploit it the same way as ARK, but just with the TN Files.

[qwikrazor87]

hmm, do you have plugins enabled? try disabling them and run it again.
You can hold R while starting TN-V, then disable plugins from recovery menu.
Then enable them one at a time and see which is failing.