sasori: http://www.mediafire.com/?gukjfzs2h6ymza0 here you are!
[RELEASE] Easy 6.20 DualBoot [UPDATED (22/05/2011) REV.B]
- Rinnegatamante
- VIP
- Posts: 840
- Joined: Sat Mar 26, 2011 10:02 am
- Contact:
Re: [RELEASE] Easy 6.20 DualBoot [UPDATED (22/05/2011) REV.B
Yadro, are you using REV.A or REV.B?
sasori: http://www.mediafire.com/?gukjfzs2h6ymza0 here you are!
sasori: http://www.mediafire.com/?gukjfzs2h6ymza0 here you are!
Advertising
If you want, visit my website: http://rinnegatamante.it 
Re: [RELEASE] Easy 6.20 DualBoot [UPDATED (22/05/2011) REV.B
B I got the same on A but once it load pro, and i can replace vshmainRinnegatamante wrote:Yadro, are you using REV.A or REV.B?
Advertising
PSP3008
- Rinnegatamante
- VIP
- Posts: 840
- Joined: Sat Mar 26, 2011 10:02 am
- Contact:
Re: [RELEASE] Easy 6.20 DualBoot [UPDATED (22/05/2011) REV.B
When you downloaded REv.B? From 22/05/2011 16:00 c.a. to 22/05/2011 19:30 there is a buggy version that could cause these problems.
If you want, visit my website: http://rinnegatamante.it 
Re: [RELEASE] Easy 6.20 DualBoot [UPDATED (22/05/2011) REV.B
I downloaded it when you updated the post to REVB.Rinnegatamante wrote:When you downloaded REv.B? From 22/05/2011 16:00 c.a. to 22/05/2011 19:30 there is a buggy version that could cause these problems.
Do you mean I sould go to Sony Service?
PSP3008
Re: [RELEASE] Easy 6.20 DualBoot [UPDATED (22/05/2011) REV.B
there are two folders which one should i choose?Rinnegatamante wrote:Yadro, are you using REV.A or REV.B?
sasori: http://www.mediafire.com/?gukjfzs2h6ymza0 here you are!
- Rinnegatamante
- VIP
- Posts: 840
- Joined: Sat Mar 26, 2011 10:02 am
- Contact:
Re: [RELEASE] Easy 6.20 DualBoot [UPDATED (22/05/2011) REV.B
Yes, i mean you must send it to Sony Assistance (sorry for the problem...i found this problem only two hours after the official release of REV.B)
to sasori: one you prefer
to sasori: one you prefer
If you want, visit my website: http://rinnegatamante.it 
Re: [RELEASE] Easy 6.20 DualBoot [UPDATED (22/05/2011) REV.B
Oh... sh... Anyway thank you. Good luck at Genesis. After fixing my PSP I'll try the new ver.Rinnegatamante wrote:Yes, i mean you must send it to Sony Assistance (sorry for the problem...i found this problem only two hours after the official release of REV.B)
to sasori: one you prefer
PSP3008
Re: [RELEASE] Easy 6.20 DualBoot [UPDATED (22/05/2011) REV.B
is there a plugin that will automatically loads up vshorig.prx?
- Rinnegatamante
- VIP
- Posts: 840
- Joined: Sat Mar 26, 2011 10:02 am
- Contact:
Re: [RELEASE] Easy 6.20 DualBoot [UPDATED (22/05/2011) REV.B
No, follow my third instruction to take your flash0:/vshorig.prx or flash0:/vsh/module/vshorig.prxsasori13L wrote:is there a plugin that will automatically loads up vshorig.prx?
If you want, visit my website: http://rinnegatamante.it 
- stevealexanderames
- Posts: 566
- Joined: Tue Mar 22, 2011 4:59 pm
Re: [RELEASE] Easy 6.20 DualBoot [UPDATED (22/05/2011) REV.B
I just installed the dualboot on my 3k 3g and... i had few problems ._. none fatal but i'd like to ask for an explanation if possible:
1) i used the revB, i did the procedure without problems and i arrived at the point "press start to install the dualboot"
i pressed start, the psp asked me for the test and i did it, okay. so i reloaded the dualboot, pressed start to install the modules, selected a non-go psp but then the homebrew freezed at the black screen where it says "loading sw" or something. then i turned off the psp (and sh****d my pants) but the psp rebooted normally. then i re-reloaded the dualboot, skipped the test and everything now is fine. was that freezing normal?
2) after rebooting the psp ask me if i want TN-D, TN-E, PRO or OFW, and i selected OFW; the psp boots to TN-D. is also this normal? ._.
3) holding select at startup make the PRO recovery flash on the screen for a while, then back to TN-D
4) holding R when booting goes to TN-D...
it is almost certailny my fault but i'd like a little explanation XD
1) i used the revB, i did the procedure without problems and i arrived at the point "press start to install the dualboot"
i pressed start, the psp asked me for the test and i did it, okay. so i reloaded the dualboot, pressed start to install the modules, selected a non-go psp but then the homebrew freezed at the black screen where it says "loading sw" or something. then i turned off the psp (and sh****d my pants) but the psp rebooted normally. then i re-reloaded the dualboot, skipped the test and everything now is fine. was that freezing normal?
2) after rebooting the psp ask me if i want TN-D, TN-E, PRO or OFW, and i selected OFW; the psp boots to TN-D. is also this normal? ._.
3) holding select at startup make the PRO recovery flash on the screen for a while, then back to TN-D
4) holding R when booting goes to TN-D...
it is almost certailny my fault but i'd like a little explanation XD
PSP 3004 3G 6.20 LME / PRO(MOD)-C

