Please help with rejuvinate 3.3 install

[joeh1974]

Greetings to all. I'm trying to install Rejuvinate for Unity 3.3, and I keep getting stuck at a certain point no matter what I do.

I have extracted the 3.3 package and copied over the necessary files. After running the SETUP.BAT file, and driver installation, I'm presented with:

"Please import your PSM+ license files as stated on the PSM+ page. Press any key to continue..."
This brings up the Publishing Utility for Unity.

I have already obtained my initial 5 files for PSM+, and followed the installation. I've also received the 2 files for the daily check-in, and installed those as well. I've imported the license key, seed, and app key from the PSM+ e-mail. The PSM Dev app for Unity on the Vita boots up fine, and doesn't give an error about being unregistered. The Publishing Utility also shows my device name, connected, with icons for Seed and App Key listed.

The problem is that the 3.3 Rejuvinate setup will not progress past the above step. No matter what I do, I can't make the command window progress. It just stops there. If I close the Publishing Utility window and try to continue, it just opens back up again.

Could somebody please explain what I am missing here? Thanks!

Advertising

[leonheart]

I have the same problem

Advertising

[joeh1974]

I have the same problem

On this problem I figured out that I had the PSM+ emails for the regular app and not unity. Google PSM+ Hackinformer and use their email system. You should get an email with 4 attachments instead of 5 for the initial setup. Then get the daily email with 2 attachments. Also, use Gmail for the email address. I learned this the hard way.